Teach you how to install transformer varnish vacuum impregnation equipment

Today, Hui Yue Chen Hao teaches you how to install transformer vacuum dipping equipment, I hope everyone can use it; the following are some basic installation requirements.

1. This equipment should be installed in a dry, ventilated and clean place.
Second, the installation should be laid flat, at least 300 mm gap between the wall or other objects.
Third, the working voltage of this machine is three-phase 380V. Pay attention to the correct wiring when charging. Check the motor steering after switching on. Seen from the end of the pump as clockwise. If the steering does not match, you can change any two of the three lines. Also note that the motor must be grounded.
Fourth, both installation and use must pay attention to the amount of oil in the vacuum pump, 3 / 2 in the oil window is appropriate.
5. The pipe connecting the pumped container should be clean and dry, and the pipe joint should be kept sealed.

6. There may be a small amount of gas discharged from the pump outlet, which can be drained and discharged by piping.