Huilei IR tunnel furnace oven debugging steps-Info-HYE high-frequency transformer automation equipment manufacturers

Huilei IR tunnel furnace oven debugging steps

   I am Dongguan, Dongguan, Yue Yu IR tunnel oven selection of new domestic insulation materials, thermal insulation and strong, the outer surface of the vacuum gold-plated infrared enhanced film, good temperature resistance, can work for more than 6000 hours. Reducer: 1200: 1 a reducer, speed control mode: frequency control, can be precise speed. In debugging is very simple, today by Hui Yue Lee S to tell you about.

1, then power
Three-phase five-wire system (three-phase 380V), FireWire access power main switch, zero line access zero line, ground access to ground level. When the power is turned on, check whether the transmission line is blocked. Press the start switch, see the motor running direction, if no operation that phase sequence is wrong, please three of the two power lines on the tone;

2, adjust the delivery time
  Adjust the number of revolutions on the digital controller, observe the change in the value, and calculate the time required for the material to flow out.

3, temperature control
  set temperature:
Press SET --- SV to flash - Move the arrow keys (left, up, down) to set the desired temperature --- Press the SET button to complete the setting.
Temperature correction:
   Measure the actual temperature at the temperature bar, if the difference between the displayed value is greater than 5 degrees, you need to modify the compensation value.
Temperature correction method:
    If the actual measurement temperature of 125 degrees, the thermometer shows 120 degrees, then the SC parameter is set to 5
The actual measurement temperature of 125 degrees, the thermometer shows 130, then the SC parameter can be set to -5.
Reminder: Change the offset parameter value. Will directly affect the furnace temperature, please measure the accuracy and then set. And then verify that the temperature is too high to cause the baked material scrapped.

4, institutional adjustment
Emission adjustment
The exhaust port has a regulating throttle, under normal circumstances for all open, if encountered in the temperature can not reach the set value can be indicated by the direction of the arrow to reduce the diameter of the damper, but not to the minimum position, this position has been closed, There is a risk that the solvent concentration is too high to explode.

5, the steps

(1) Turn the air switch handle to the ON position, turn on the main power, and turn on the power indicator.

(2) boot, turn on the power switch, and then open the transport control switch (do not need to be disabled), and then open the hot start switch, the lights are lit, into the working state.

(3) stop, turn off the first turn, and then turn off the switch, and then press the emergency stop, the machine stops working.

More about Dongguan Huiyue technology IR tunnel furnace oven Welcome to our company Dongguan Yue Yue more technical advice!


HUIYUE	KEPIN