HUIYUE (DongGuan City) Automation Equipment Co., Ltd.Our Dongguan Huiyue IR tunnel oven selection of new domestic insulation materials, thermal insulation and strong, the outer surface of the gold-plated infrared enhanced film, temperature, and can work more than 6,000 hours of continuous work. Reducer: 1200: 1 reducer a, speed mode: frequency control, precise speed. Debugging in the area is very simple, today by Hui Yue Li S tell you about.
IR tunnel oven oven
1, connected to electricity
Three-phase five-wire system (three-phase 380V), FireWire access to the main power switch, zero line access to zero line, ground wire access ground. After power is on, check the transmission line for blockage. Press the start switch to see the direction of motor running, if not running that the phase sequence is wrong, please the three-phase of the two power lines swap;
2, adjust the delivery time
Adjust the rotating terminal on the digital controller, observe the change in the value, according to the speed of material out of the required time.
3, temperature control
set temperature:
Press SET --- SV flash --- Move the arrow keys (left, up, down) to set the desired temperature --- press the SET key to complete the setting.
Temperature correction:
Measure the actual temperature at the temperature bar, if the display value and the difference is greater than 5 degrees, you need to modify the compensation value.
Temperature correction method:
If the actual measurement temperature of 125 degrees, the temperature table shows 120 degrees, then the SC parameter is set to 5
The actual measurement temperature of 125 degrees, the thermometer shows 130, then the SC parameter can be set to -5.
Reminder: Change the offset parameter value. Will directly affect the furnace temperature, the temperature is accurate and then set. Re-verification, to avoid the temperature is too high caused by baked materials scrapped.
4, institutional adjustment
Adjustment of exhaust gas discharge
If the temperature is less than the set value, the direction of the arrow can be reduced to reduce the diameter of the damper, but can not reach the minimum position, the position of the damper is fully closed, and the exhaust door is fully closed. The solvent concentration is too high and the risk of explosion.
5, steps
(1) Turn the air switch handle to the ON position, turn on the main power, the power indicator light.
(2) Power on, turn on the power switch, and then open the transmission control switch (do not need to not enable), then open the hot start switch, the light is lit, into working condition.
(3) shutdown, turn off the first heating, and then close the transmission switch, and then press the emergency stop, the machine stops working.
More related to the Dongguan Huiyue IR tunnel oven oven details please call the Division I Dongguan Huiyue Technology Consulting!
